Honeywell Pro 3000 Installation Manual

CPH default is 3, I confirmed this during setup. I connected the new thermostat as suggested. O = O G = G Y = Y B = C R = R T = Tape off this thermister wire X2 = E W = Aux The heat pump stays on all the time. I can unplug the thermostat cover and the heatpump will continue for a minute and then shut off. I talked to Honeywell and was told to contact a licensed 'Honeywell' contractor or go to Lowes/Home Depot and get a 'homeowner' model. I was hoping this would be a simple install and not require removing the heat pump panel and trace the wires. Heat Pump is a TRANE model: TWE024C140A0 sn: N393PC21V Old (I mean really old) Mercury thermostat: WEATHERTRON BAYSTAT240A R T O G Y X2 B U-W-F U, W, F are all tied together New thermostat: Honeywell PRO3000 TH3210D1004 E Aux Y G O L R B C.

PRO TH3000 Series. Non-Programmable Digital Thermostat. Operating Manual. System Status. • Cool On: Cooling system is on. • Heat On: Heating system is on. • Em: Emergency heat is on. • Aux: Auxiliary heat is on. Quick reference to. Install fresh batteries when the REPLACE.

The wiring is correct. Does function 1 show up in configuration mode? All is running well. Patience on my part may have played a role in the delay.

The 5 minute compressor protection delay really messed with me. Seemed like forever. It took quite a while to cycle through and confirm all of the heating and cooling modes since you have to wait 5 minutes in between.

Also, the fan stays on for 90 seconds after reaching temp. This was longer than I was used to. Christian Dance Songs Malayalam Mp3 Free Download. The thing that really made me concerned. Import Xyz Points Into Autocad Blocks.

When I hook up the new thermostat and it is in the OFF & AUTO mode, the fan would turn on when I flipped the breaker on. It ran for quite some time. I think I am going to like this thermostat. Thanks to everybody for your guidance.